ls
to see the content of /mnt This is an old revision of the document!
Reflash using an USB Stick
YouTube video: http://youtu.be/axQvgqvlhcU
The following howto works, if you already have usb drivers (pre) installed. This can be manually or within a custom image. The HowTo applyies to the most devices, it uses the MR3020 as an example.
- Download Image to your computer, refer to our hardware list choosing the correct file.
- Power off the MR3020
- Take your USB device and put the downloaded file to your usb device
- Connect the MR3020 to your computer via Ethernet.
- Set up your of the computer to 192.168.1.2
- Start to ping 192.168.1.1 (this is the failsave IP) infinitive
- Power the MR3020 on and when the WPS Button starts to blink , push it (it will blink faster)
- You see the ping getting response
- Run
telnet 192.168.1.1
- Plugin your USB Device to the pbx-router
- Do the following commands:
/etc/init.d/boot start (This will return some error messages - ignore it)
- Try
mount /dev/sda1 /mnt cd /mnt/ mtd -r write <your filename> firmware
- The device reboots automatically after successfully flashing. 1)
If mount does not work, you can do
mount_root
Wich mounts your root partition and you can edit files. after you are finished run
reboot -f
1)
If you can't remember the filename type