Differences

This shows you the differences between two versions of the page.

--- raspberry_pi:diy:manual [2014/11/23 04:09]
darts created
+++ raspberry_pi:diy:manual [2017/07/02 07:59] (current)
matthias [Manual install] added php
@@ Line 1: / Line 1: @@
-===== Raspberry Pi(rate)Box 1.0 DIY =====
+===== Raspberry Pi(rate)Box 1.0 & 2.0 DIY =====
-**Note:** The Raspberry Pi(rate)Box 1.0 is currently under development. The instructions below will be updated when the new Raspberry Pi(rate)Box 1.0 image is completed. In the interim, check out the **[[http://forum.daviddarts.com/list.php?7|PirateBox Forum - Raspberry Pi]]** discussion board for more info and support.
+<wrap tip>
+**Note:** This howto is for crafting your own PirateBox image. Currently we have prebuild images for all RaspberryPi versions available. You find further instructions on [[:raspberry_pi:diy|the Raspberry Pi DIY]] page.
+</wrap>
 ----
-**Known working USB Wifi-dongles:**  [[piratebox_wifi_compatibility|RaspberryPI PirateBox compatibility list]]
-[[http://blog.danielpecos.com/2013/09/raspberrypi-custom-command-button/#more-648|RaspberryPI Shutdown button via GPIO]]
-==== Custom Image ====
+**Known working USB Wifi-dongles:**  [[:raspberry_pi:piratebox_wifi_compatibility|RaspberryPI PirateBox compatibility list]]
-:!: :!: Custom image seems broken :!: :!:
+[[http://blog.danielpecos.com/2013/09/raspberrypi-custom-command-button/#more-648|RaspberryPI Shutdown button via GPIO]]
-Support-Thread for Image-Issues: http://forum.daviddarts.com/read.php?2,6298
-  * Download this imagefile: [[http://downloads.piratebox.de/2013-02-06-wheezy-raspbian-PBx06F.zip| 2013-02-06-wheezy-raspbian-PBx06F.zip]]  (MD5SUM fba9dea3aa404460184ee3d145a8f4fc)
-  * Install Raspberry as normal:  http://elinux.org/RPi_Easy_SD_Card_Setup  (But use the image above instead)
-  * Boot as normal with a Monitor, Keyboard & connected LAN (DHCP with Internet access) :!:
-  * Do the following steps in Raspi-Config
-    * Enable SSH Server via raspberry-config
-    * change Password
-    * Expand FS
-    * Finish & reboot now
-  * After this you have can enable it with
-   # sudo /etc/init.d/piratebox start
-  * And if PirateBox should start via startup, run the following line
-   # sudo update-rc.d piratebox  defaults
@@ Line 50: / Line 30: @@
   * Install needed packages and prepare some stuff:
-   # sudo apt-get update
+    sudo apt-get update
-   # sudo apt-get -y install lighttpd
+    sudo apt-get -y install lighttpd
-   # sudo /etc/init.d/lighttpd stop
+    sudo /etc/init.d/lighttpd stop
-   # sudo update-rc.d lighttpd remove
+    sudo update-rc.d lighttpd remove
-   # sudo apt-get -y install dnsmasq
+    sudo apt-get -y install dnsmasq
-   # sudo /etc/init.d/dnsmasq  stop
+    sudo /etc/init.d/dnsmasq  stop
-   # sudo update-rc.d dnsmasq remove
+    sudo update-rc.d dnsmasq remove
-   # sudo apt-get -y  install hostapd
+    sudo apt-get -y  install hostapd
-   # sudo /etc/init.d/hostapd  stop
+    sudo /etc/init.d/hostapd  stop
-   # sudo update-rc.d hostapd remove
+    sudo update-rc.d hostapd remove
-   # sudo apt-get -y install iw
+    sudo apt-get -y install iw  php-cli php-cgi
-   # sudo rm /bin/sh
+    sudo rm /bin/sh
-   # sudo ln /bin/bash /bin/sh
+    sudo ln /bin/bash /bin/sh
-   # sudo chmod a+rw /bin/sh
+    sudo chmod a+rx  /bin/sh
@@ Line 81: / Line 61: @@
   * Fetch and copy over PirateBox Source
-   # wget  http://downloads.piratebox.de/piratebox-ws_current.tar.gz
+    wget  http://downloads.piratebox.de/piratebox-ws_current.tar.gz
-   # tar xzf piratebox-ws_current.tar.gz
+    tar xzf piratebox-ws_current.tar.gz
-   # cd piratebox
+    cd piratebox
-   # sudo mkdir -p  /opt
+    sudo mkdir -p  /opt
-   # sudo cp -rv  piratebox /opt
+    sudo cp -rv  piratebox /opt
-   # cd /opt/piratebox
+    cd /opt/piratebox
-   # sudo sed 's:DROOPY_USE_USER="no":DROOPY_USE_USER="yes":' -i  /opt/piratebox/conf/piratebox.conf
+    sudo sed 's:DROOPY_USE_USER="no":DROOPY_USE_USER="yes":' -i  /opt/piratebox/conf/piratebox.conf
-   # sudo ln -s /opt/piratebox/init.d/piratebox /etc/init.d/piratebox
+    sudo ln -s /opt/piratebox/init.d/piratebox /etc/init.d/piratebox
-   # sudo update-rc.d piratebox  defaults
+    sudo update-rc.d piratebox  defaults
-   # sudo /etc/init.d/piratebox start
+    sudo /etc/init.d/piratebox start
@@ Line 137: / Line 117: @@
 After this, the box is accessible under 192.168.77.1 (instead of 192.168.1.1 on OpenWRT)
+===== Post-Installation =====
+==== Activate the Kareha Image and Discussion Board ====
+Enable the Kareha Image and Discussion Board on the piratebox:
+  sudo /opt/piratebox/bin/install_piratebox.sh /opt/piratebox/conf/piratebox.conf imageboard
+Use the vi text editor ([[http://www.lagmonster.org/docs/vi.html|vi cheat sheet]]) to change the admin username and password (__ADMIN_PASS__ and __SECRET__). Don't forget to remove a leading **#** in the both lines, if exists:
+  sudo vi /opt/piratebox/www/board/config.pl
+==== Activate Timesave Functionality  ====
+Enable Timesave support on the piratebox:
+  sudo /opt/piratebox/bin/timesave.sh /opt/piratebox/conf/piratebox.conf install
+==== Activate the UPnP Media Server ====
+First, install minidlna if it is not present on the system. WARNING: your raspberry pi must be connected to the Internet to download remote packages:
+  sudo apt-get install minidlna
+Then, save minidlna default config file and replace it with the one provided with piratebox:
+  sudo cp /etc/minidlna.conf /etc/minidlna.conf.bkp
+  sudo cp /opt/piratebox/src/linux.example.minidlna.conf /etc/minidlna.conf
+Finally, configure the system to automatically start minidlna when power up:
+  sudo update-rc.d minidlna defaults
+  sudo service minidlna start
+The minidlna should start.